久久国产久_baoyu133. con永久免费视频_中文字幕一区在线观看_视频一区 中文字幕_www日韩_亚洲综合国产

 

1. Raw materials for preparing atomic ash and curing agent: Atomic ash is a type of slag, usually generated as waste or by-product from metallurgical production processes. The curing agent can be selected from suitable silicate materials. Ensure that the atomic ash and curing agent comply with relevant standards and specifications.

 

2. Mixing ratio: Determine the mixing ratio of atomic ash and curing agent based on specific needs and curing requirements. Normally, the amount of atomic ash is between 10% and 30% of the total mass of the curing agent.

 

3. Mixing: Place the atomic ash and curing agent into a suitable mixing container, and mix thoroughly with a mixer to evenly distribute the two materials.

 

4. Adding water: Gradually add an appropriate amount of water to the mixing container according to actual needs for mixing. The amount of water used needs to be determined based on the specific water cement ratio requirements of the material. During the stirring process, it is necessary to maintain an appropriate stirring speed and time to ensure uniform distribution of the solution.

 

5. Adjust viscosity: If the viscosity of the solution is too high or too low, necessary liquid additives need to be added according to the actual situation to ensure the fluidity and suitability of the solution.

 

6. Testing and adjustment: After mixing, relevant experiments and tests can be carried out, such as measuring the flowability and setting time of the curing agent, and necessary adjustments can be made based on the test results to obtain a curing agent solution that meets the requirements.

 

Precautions:

 

-During the blending process, safety operating procedures should be followed to maintain a clean and ventilated operating environment.

 

-The mixing container should be clean, dry, and free of impurities.

 

-After mixing, it needs to be stored in a sealed container to avoid evaporation of water and mixing of impurities.

 

Please note that the above methods are for reference only, and the specific methods for preparing atomic ash and curing agent need to be adjusted and optimized according to specific circumstances and material requirements.